Restor red hat xwindows

Go to Application. Was this helpful? Yes No. We appreciate your feedback. Reboot and remove SRD media. Note: If swap partition is not enabled after rebooting, refer to article Note: If it takes a long time when booting from the recovered system after recovering, refer to article Please note that this document is a translation from English, and may have been machine-translated. It is possible that updates have been made to the original version after this document was translated and published.

Veritas does not guarantee the accuracy regarding the completeness of the translation. You may also refer to the English Version of this knowledge base article for up-to-date information.

Support Knowledge base Article: Last Published: Ratings: 3 1. Product s : System Recovery. See Figure 12 Figure 12 Activate VG using the below command. Restore all recovery points. Set swap partition using the below commands. Reboot and remove SRD media. Note: If swap partition is not enabled after rebooting, refer to article Note: If it takes a long time when booting from the recovered system after recovering, refer to article Please note that this document is a translation from English, and may have been machine-translated.

It is possible that updates have been made to the original version after this document was translated and published. Veritas does not guarantee the accuracy regarding the completeness of the translation.

You may also refer to the English Version of this knowledge base article for up-to-date information. Support Knowledge base This light-weight graphical clock application is commonly used to test whether a user can successfully display X applications to their X-display. Run the xclock command to display the xclock application, for example:. This key combination should cause the X-Server to exit crash and, if possible, restart.

If that fails, you may need to reboot the system. After the system has rebooted, verify that your video hardware is compatible. Error number Connection refused is a message from an X client any program attempting to connect with the X-Server e. Generally, you only see the last few lines of the error message. For the entire message to help troubleshoot this issue run the following command:. This will create a file called start.