Harley grips install

As a side note: When installing your throttle grip, slide it into place and then tighten it down, but turn your throttle just slightly and release it. If the grip sticks, one of two things has happened. The latter is what happened to me. I slid it into place, tightened everything down and then tested the throttle to find that it was sticking just slightly.

For the clutch side, the motorcycle grip installation is a bit different. The grip is held in place by two screws that sit on the inside flare. With the divots drilled, slide the grip back into place and secure it with the two included screws, using a drop of medium duty thread locker such as Loctite. Follow the label instructions and make sure to let it cure before riding.

Quick Tip: When sliding rubber grips into place, fill the grip with rubbing alcohol before attempting to put it onto the bar. The alcohol will act as a lubricant, but will evaporate quickly to let your adhesive cure. Just as you did on the throttle side, loosen your screws and slide the clutch housing into a position that allows it to sit next to the grip, or allows the inner lip of the grip to sit inside the housing if that is how your grips are designed.

Installing grips is a quick and easy project. With only a couple of tools required, most any rider should be able to knock out an install in an hour or less. The Tracker grips from Roland Sands Designs have been great for me. They have a slightly larger diameter than the stock grips, but not so much that I had to adjust any levers. The wider grip makes them more comfortable for me, and the Renthal rubber means that my hands never slip. I love the blacked out look that I chose, but there are a few different finishes to match any application.

Removing Stock Harley Grips Loosen housing on throttle side Slide grip off from handlebar Loosen housing on clutch side Pry or cut grip off from handlebar For most bikes, removing the stock grips is a pretty simple process.

Installation of New Grips Throttle Side Slide throttle grip or throttle tube into place If using a throttle tube, slide grip over tube Tighten housing Check to see that grip returns to neutral position If grip sticks, adjust housing tightness or slide grip out slightly Clutch Side Slide clutch side grip into place Mark location for drilling divots Remove grip, drill divots If desired, apply grip adhesive to bar Slide grip into position, tighten placement screws Allow glue to dry according to directions Depending on which grips you choose, your installation process could be slightly different.

Or so I thought. There are many different styles of aftermarket grips for Harley. Grips not only add style, but comfort depending on the thickness. Note: If you appreciate this free video, consider supporting us by purchasing these grips or any other items through our Revzilla Affiliate Link.

No additional cost to you, but if you click through and make a purchase, we get a small kick back. Your email address will not be published. Join the Free Email Club! If you appreciate this free information make sure to join the thousands of law abiding bikers that have already joined the free Email Club! You will be notified of new useful motorcycle content and techniques as we put them out.